What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 17:37

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
It also is a device that limits the change in current flow.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Consequatur explicabo natus minima expedita.
what exactly is a ‘surge’ protector?
eight
(Dc diagram shown, AC is similar).
Iure eveniet quod quae esse explicabo autem corrupti.
A circuit breaker is similar, but is resettable.
So, the voltage could go up to 500 volts, and the fuse will not open up.
The other is “what does a “fuse” do?”
Eos iste et tenetur sunt rerum eligendi.
This is 'the assistant's answer'
This device then solves the entire problem.
The third is lightning and “how it gets conducted into a home.”
Can we state Alia Bhatt as the most versatile actress in Bollywood now?
2024–10–10[John johnson John Johnson ]
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
But… the neutral is now “floating” because of the 1 ohm resistance.
Cocaine Sharks: The Disturbing Discovery That’s Shaking Marine Research - Indian Defence Review
An AC voltage/ current source, and an ac inductive load.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
When will dating stop being so hard for Gen Z?
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
He then describes the function of a fuse.
This is where the MOV conducts again, and dissipated the energy.
nine
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
For this case there are devices called Metal oxide varistors (MOV).
Why is the word "democracy" not in the preamble of the US Constitution?
There are three different concepts here that are getting confused.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
One
S&P Dow Jones Makes No Changes to S&P 500 in Quarterly Rebalance - Bloomberg
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Poop Transplants Not All They’re Cracked Up to Be - Gizmodo
What does a fuse do?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
First Sentence:
One is “what exactly is in a ‘surge protector’ ? ”
These devices are installed between the “hot” and “neutral” and protective ground.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Biotech pauses trial after second patient death linked to gene therapy - The Washington Post
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
2024–10–16 [ OO OLAOYE OYEBODE ]
Now when you have a certain ac resistance, then a current flows in a loop.
What's the most impressive feature of Claude AI according to its users?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
In schematic diagrams this is the symbol for a fuse:
the problem then depends on "how fast does the fuse operate?".
I post the exact comment here.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
At one ohm, the resistor has a maximum of 1 watt power.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
What is lightning?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
so, what happens?
[old diagram got deleted by accident]
It seems Mohan does not understand the difference between a comment and an Answer.
Because the load is inductive, the current lags the voltage.(by a bit).
[image of Common-mode choke]
This is where this question deviates from being a 'generic' question, and becomes more specific.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
a photo is worth a thousand words.
At least they know the answer if they wanted it.
He then asserts :
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–14 [Omar Gharbi Omar Gharbi ]
He then describes Rainy Season and Lightning.
There are two important concepts here.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Here is a simplified AC power diagram.
but this device (an Inductor) … impedes the rapid changes in the current.
This one hit behind the barn.
A fuse is a non-resetable over current circuit protector.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
The bolt then partially travels down the line to your home.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Edit 2024–10.
Barnstars:
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The MOV will conduct when the voltage exceeds 50% of line voltage.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Upvotes:
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
but I think this circuit , shows a few more pieces.
These are simplified answers to the original question, and does not change anything I wrote above.
But it can get overloaded, and no longer works.